Slicksskruv 35 st

Slicksskruv 35 st.

Används för att skruva fast däcket i fälgen för att unvika att däcket roterar i fälgen.

• These Screws Are Cadmium Plated
• Kit Contains 35 Self Tapping 1/4" Screws.

MICKEY THOMPSON PROPER INSTALLATION OF RIM SCREWS WITH TUBE TYPE TIRES

• Begin by drilling 16 equally spaced holes on both the inner and outer flange of the rim.
• Note: (Mickey Thompson strongly suggests that you use Drag slick mounting screws only, and that you follow the rim screw manufacturers suggested drill bit size.)
• Trial run the screws through all 32 holes. Running screws in the hole and back out again. A dab of grease on the screw will help.
• Check for any sharp edges that the screw may have pushed out or caused during the trial run through. If any sharp edges are found de-bur and make sure the inner bead flange of the rim is smooth and clean.
• Mount tire and tube. Have an experienced professional install the tire and tube on proper equipment. (Refer to Mickey Thompson Tech Bulletin #2 for tube mounting procedures and Mickey Thompson Tech Bulletin # 8 for proper procedures to check rollout (circumference).
• Before installing the screws, inflate the wheel and tire assembly to 20 psi. Put a small amount of grease on each screw and install into wheel and tire assembly. Deflate assembly to operating pressure. Inspect rim flange and bead area for proper bead seating. If bead is not fully seated, re-inflate and reinstall screws.
• For best results, “Bubble Balance” is STRONGLY RECOMMENDED when bubble balance is not appicable, static balance is okay. NO ROAD FORCE BALANCE ON ALL M/T DRAG RACING TIRES.
• Periodically you should check the wheel for loose screws and inspect the rim bead area to be sure that there is no bead area separation.

Levereras i set om 35 skruv. Räcker till 1 hjul om man följer tex M/T installationsråd.

Säljs i kit om 35 skruvar.